Automatic Design - List of features available in SolidGeometry 5.6

ashft	creates a irrational number between and 66 degree (1.155 rad)
CPLTopCM_SUN	automatic design of a compliant mechanism based on topology optimization techniques.
SGattachMotorN40	adds motor rack to another rack and subtracts the bore for an motor axis
SGboxbolted	creates a box that is closed by a simple lid cover
SGboxturnswitch	Solid Geometry for 6V Batterie box plus 1 turn-switch to support simple DC-Motor control
SGcablewinch	creates a solid for a cable winch
SGcapontopprojection	create a simple cap ontop
SGcatheterroller	Creates for a cather lock a gear drive
SGclosurecapFDM	creates a top cover for FDM Printing
SGcut2fit	cuts a large solid into smaller pieces to be fixed with screws
SGcylhinge	Creates a piano hinge as a joint
SGfreewheel	Creates a freewheel for a wind up motor
SGgearboxhousing	creates a housing for a gear box
SGgearratio	calculates automatically the required gear sequence for a gear box
SGhollowrhombus	creates a hollow soild for FDM printer
SGlockingDIN912DIN985	Returns two bodies with DIN912/DIN985 locking method
SGmotorhousing	returns a housing betwenn Base frame 'B' and end of motor
SGofCPLzplugin	created extruded solids that can be pluged in if they are very long
SGofCPLzscrew	Extrudes a CPL in z with an internal scew to print the part separately as FDM
SGofFSCPLextrude	creates a solid be extrudsion of the feature surface selection
SGpipeclamp	designs a foldable double pipe clamp with hinge.
SGrackofSGshaftaxis	design automatically racks for rotating shafts and axis
SGsculpturepedestal	create a pedestal for a sculpture
SGseedcube	Creates a small cube below the surface with just one Frame 'F" to start SGdesingconcepts
SGselectGroupofBBvol	returns the solid ordered by volumes
SGservomounting	shows how to create servo motor mounting sets
SGstamptextFDM	creates an imprint or an relief if allowed
SGTconnectingplug	returns a solid part that can be used to connect both solids by a positive connection
TLconnecting2SG	connects 2 solids by a straigt connecting solid between the center, using feature surfaces